Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE USE OF ANTIPUMPING CONTACTOR IN HT BREAKERS
- 8 Answers
- 11634 Views
- I also Faced
- E-Mail Answers
Answer Posted / n.srinivasarao
IT is Protection of closing coil.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
Explain what is clipper and clamper circuits?
What is electrical cable termination
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
What is Annunciation?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
How many devices can be connected in one zone of FACP
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
