Interested to Buy Any Domain ? << Click Here >> for more details...
If the load of transformer is getting more than its
rating,,,than how to overcome this problem? Suppose thee
rating of transformer is 315kva and the load is going
beyond than the rating say around load: 352kva...
Than how can we solve this problem without deducting the
load.
- 14 Answers
- 23224 Views
- Hyundai, I also Faced
- E-Mail Answers
Answer Posted / joy banerjee
Dear Subh
When the transformer is overloaded the insulation becomes
weak resulting in lower life of the tarnsformer. Moreover
the cables will also get overheated and may catch fire.
Also as mentioned by Kaushal the efficiency will also
decrease. Hence the answer should be as per SAGAR's or
ASIF's reply.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
i need mat lab program to find out the transmission line losses,regulation and losses
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
As an electrical engineer what are the responsibilities which i can hold in TCS?
what is feeder bay?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
what is ground fault in ACB?
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
Can clean earth cable be considered as low current cable
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
how to revers the direction of single phase motor
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
whate is the meaning of balance/unbalance,in stabilizers type
