Interested to Buy Any Domain ? << Click Here >> for more details...
which trsanmission is easy and cost effective AC or DC.
- 19 Answers
- 19644 Views
- I also Faced
- E-Mail Answers
Answer Posted / venu
my dear frnds all of u right but actualy this transmison is
a distsnce constrain if the trans dist is more than 500 km
then dc is bst else ac trans k
thanq
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
write down the formula of cable size in RM if current is 50Amp.
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
What are the three major categories of error?
Why squirrel cage motor can only use with low starting loads ?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
can anyone provide me a amf panel control wiring using ec-2 relay?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
What will be the current if the resistance total in a series circuit doubles?
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
Phase control and integral control are used for?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
