Answer Posted / rachuri_sree

You need to know the distace between source of supply and
the load. consider a voltagedrop of 5%. i.e. 5V for a 440v
system. use the formula V=IR from this you will know the
resistance required for your requirement. (I is the load
that you want to connect). Use R=Pl/a to find the correct
cross section of the cable. (P is resistivity of either
copper or Aluminium, l is the distance).

What is mason's gain formula?

1220

---

at what base you will tell the direction of rotation of dc motors and generators?

1078

---

Draw the DOL starter and star delta starter drawing?

2937

---

If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?

2160

---

Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?

1417

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

1808

---

what is the difference b/w ground & virtual ground?

2264

---

What is the estimated total hydropower potential of india?

1085

---

If i am running of spindle at 2000rpm ,but How to spindle stop at the second I am resetting the machine in CNC machines

1579

---

What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?

2234

---

How will change the frequency in distribution side?

1738

---

Why High voltage are generate noise ?

1435

---

1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?

2012

---

how does a submersible pump work..?

1818

---

State thevenin’s theorem?

1026

---