Interested to Buy Any Domain ? << Click Here >> for more details...
Electrical Diagram of Electric Arc Furance from transformer
to Furances
- 1 Answers
- 5705 Views
- I also Faced
- E-Mail Answers
Answer Posted / rachuri_sree
The cuurrent in the secondary of the arc furnace will be
very high i.e. in kA. Hence the secondary will be devided
into no. of small bus bars and will be connected to the 3
electrodes to form a Delta, using copper hollow tubes and
flexible hoses. Water will be circulating in the copper
tubes for providing cooling. There will be a provision to
change the primary connection either in star or in delta.
Three single phase transformers can also be used instead of
only one 3 phase transformer.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is UPS and How do you maintain the UPS Maintenance? Brief Description on UPS maintenance.
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
What are the types of windings according to the construction?
i want wipro vlsi placement pattern please send me
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
what is negative and zero impedance in 3 phase induction motor ??
why do we not use equivalent voltage source in negative sequence equivalent ckt.
Describe Non I.S. Earth System and why is it used?
What is the power factor of an alternator at no load?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
As i want some model question paper in basic computer science and history please send me immediately sir
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
