Interested to Buy Any Domain ? << Click Here >> for more details...
why we used to transmitt the power at higher voltage why
not at lower voltage
- 8 Answers
- 9387 Views
- I also Faced
- E-Mail Answers
Answer Posted / achin bansal
AT HIGH VOLTAGE LINE CURRENT IS LOW THEREFORE LINE LOSSES
I2R WILL BE LESS AND OVERALL LINE EFFICIENCY WILL BE HIGH....
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is vacuum circuit breaker.define with cause and where be use it device?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
how to find impedance , mutual indatnce in transmission lines
What is the previous name of Cox's Bazar
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
Air refrigeration cycle works on the
What are gain margin and phase margin?
how to test reverse power trip?
what is the minimum voltage require to injure our body?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Can any body tell gulf interview question for experienced electrical engineer ?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
How can I known multiplying factor .without multiplying table
how to protect motor in dol starter having capacity of 30 hp.40 hp?
