Answer Posted / anand kumar shukla
as we know very well .we are use the busbar in busduct
because the current bearing rating of busbar is too much
high in compare to the cable.
we use the 150 x12 mm
150 x10 etc.
so the busbar mechanical strenth is too much strong than
cable. and busduct life is too long in compare to cable.
Is This Answer Correct ? | 65 Yes | 9 No |
Post New Answer View All Answers
Define corner frequency?
What do you mean by pull of electromagnet?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
What is tan delta & PPM in transformer? and whats its IS value?
what's the exact magnitude of current, flows through Neutral?
What is the role of feedback in a closed loop control system?
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
Can clean earth cable be considered as low current cable
Why ground terminal is used in pot meter 10k ohms
If a high resistance fault occurs,then what are the changes will happen in the system?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
what is plunger and what's the use of it in motor alignment?
what are the different methods for the starting of a synchronous motor.
why does connected a indutor with mnsformeretering core of current transformer ?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?