Interested to Buy Any Domain ? << Click Here >> for more details...
We have AC-transformer 110/13.8kv,40MVA.If DC-Voltage=110kv
is applied in its primary what will happen?
- 6 Answers
- 9160 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivashankar
It will act as short circuit, bcoz the rate of change of
flux will induce voltage in sec,whereas in Dc there is no
such phenomenon ..R=V/I..if V=0 R=0/i ultimately R=0......It
nay tend the transformer to overheat ...
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
What do you mean by pull of electromagnet?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
List examples of current sources?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
WTA used cb?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
What are the applications of autotransformers?
How to check the cable fault / hv test of transformer cable.
What is kvar?
What are the electrical engineer roles and responsibilities in chemical plant?
what is servo motor and how it works?
how to calculate the lightning arrester conductor @ no of earth pits required
how diside ct mf exmp.200/5 ct
