We have AC-transformer 110/13.8kv,40MVA.If DC-Voltage=110kv
is applied in its primary what will happen?
- 6 Answers
- 6994 Views
- I also Faced
- E-Mail Answers
Answer Posted / adel
no voltage produced in secondry winding
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
is it possible to have dc motors on single chip
size of condotory fron voltage level
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
What is lifting power for 1 wb/m2 and 1 A magnet?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
how power is generated,and transmitted to our home..pls explain briefly in simple words.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
give single line diagram of D.G distribution form alternator to main L.T panel?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
raleigh method
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
