If i want to build 230kv substation what are the equipments
to be installed?
Answer Posted / viswanathan karthikeyan
Basic Concept :
Incomer
Outgoings
Main Incomer -Cable or OHL LINE -PLEASE CONSIDER
STEPDOWN AUTO TRANSFORMER-220/132kV
NEXT AGAIN STEPDOEN TRANSFORMER-132/33Kv
stepdown Transformer-33/0.415kV
MAIN INCOMER NEED CIRCUIT BREAKER
220KV GIS
132KV GIS
33KV GIS
IF OHL LINE MEANS
gantry
WAVE TRAP
SURGE ARRESTER
COUPLING CAPACITOR
AAAC CONDUCTORS,TOWERS ETC(d0,d2,d6,d9,dt)
CABLE MEANS
220KV CABLE
CONTROL AND REALY PANELS
220,132,33 FOR RELAY AND PROTECTION PANEL
LV,HV,EHV CABLES
EARTHING MATERIALS
EARTHING AUXILLARY TRANSFORMER]
NEUTRAL EARTHING TRANSFORMER
TELECOMMUNICATION PANEL
SCS SYSTEM
BATTERY AND BATTERY CHARGES
EOT CRANE
PUMPROOM
LIGHTING AND LIGHTNING PROTECTION
EARTHING MATERIALS ETC
SO MANY ITEMS REQUIRED
I AM DOING THIS TYPE OF PROJECT
IF ANY DOUBT ,PLEASE SEND MAIL TO ME-vkn.1980@gmail.com
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
why dc is used in control circuits for MV & LV switchgeras instead of ac
What is meant by short-pitched winding?
How to calculate Temp from Resister from PT100 equation,
whats the application of voltage regulation? and whats the voltage regulation's device?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
What is a compensator?
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
why the NGR (neutral grounding resistor) always OFF during DG off?
Which level of the Transformer oil got dielectric strengh? And why?
where rlc series ckt used?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
why does a dc machine has high efficiency while working as a generator than as a motor ..
How to configure the drives in PLC, through Profibus commnication. And to how to address it?