Interested to Buy Any Domain ? << Click Here >> for more details...
How much voltage we get between two wire of 4 to 20 ma
output? Is this voltage up or down respectvice to 4 - 20
ma ?
- 9 Answers
- 14186 Views
- I also Faced
- E-Mail Answers
Answer Posted / srinivasansureshkumar
yes, it is.
Better to verify transmitter power Vs load Graph.(TX
manufacturer Manual)
you will understand a lot about the question related then
just understanding the 4~20 ma in normal condition.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is offset in a control system.
what is the reset offset and control system in instrumentation
what does it mean an active front end in vfd plz explain it briefly
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
what is actual drum level and compensated drum level?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
explain key exchanges in all security modes WPA,WPA2,TLS?
Calibration of controller (pneumatic)
how many types of preheaters are in cement industry & what r they can any body explain?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
can you send remote seal interface level transmitter calculation steps for oil water saperator.
