Interested to Buy Any Domain ? << Click Here >> for more details...
suppose we using 3 phase motor of 440 v means what range
of C.T. is require for measuring current ?
- 9 Answers
- 11557 Views
- I also Faced
- E-Mail Answers
Answer Posted / soewinaung
We must know full load ampere of the motor.If we know ,we
can select C.T. as their ratio to show on ammeter. It is
best to use ammeter selector to know ampere on each phase.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
What is the function of probe in cro?
Why we use ups battery and dsdb battery in thermal power plant
difference between the applicability of nortons and thevenin theorem
how to calculate fuse rating for a motor
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
any earth foult trip the relay but in welding time not trip by earth foult
what is relay what is protection & contact multiplying relays where it is used function in brief
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
nwhat are the main Components of servo motor?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
what is lumped and distributed elements?
Why control of DC motor is simpler?
state the working principle of incondenscent tube?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
