what is the suitable voltage of transmission line to
transmit 10000w power through 250 km.
(a)11kv
(b)33kv
(c)66kv
(d)132kv
]and please tell me whats the logic behind it
- 7 Answers
- 19127 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / nilesh chitalia
I prefare 132 KV for Transmit 10 KW because of high
distance, at high distance of transmission there is a high
loss of power in low voltage, otherwise the the diameter of
the conductor should be high and ultimately the cost of
conductor shall be high. So, It is better to transmit at
250 km, 132 KV is better.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Is there any abbrevation for STUB in Stub bus protection
2. What are the parameters of EHT sub-station?
Disadventage of cable-gland earthing if any ?
What is block diagram?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
How to calculate the value of earth capacitance in a transmission line.
Is there any specialised book to refer about fault level calculation both in MV and LV side??
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
Can RCD's used to protect the VVVF drive if not why.
The moisture in air will condense at
What are the major reasons for balancing hydro-thermal mix?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
