Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kash_if101@yahoo.com
i am kashif haider naqvi from WAH ENGG. COLLEGE,PAKISTAN.
I am going to mqke my country best in engg. ways like wise
china and japan.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
What is usage of rotameter and hydrometer.
What for schmidt plot for is used in heat transfer problems ?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
How much fuel is to be burn for production of 1 ton steam?
Plese give us information Service Special Tools for Hydraulic,Trasmission,Main clucth,Rear axle etc for Mahindra Tractor 6030-4WD,Like SST Number,Discription,Price and Dimension or Photograph if u have.Thanks
Explain difference between fissile and fertile materials?
What is stellite ?
What is the cause of pressure drop in a centrifugal
How to check the round duct measurement
What is, if any, the orientation of the horizonal seam on ERW welded pipe
why we are using mineral wool as insulation material than glass wool , in india?
CATIA:SPRING WITH SOME RADIUS AXIS
why coposite materials are sronger than solids
Sir, In the current session I am attending the Junior Engineer Exam in Grade II for Mechanical Engineering. If it possible. Please sent the Past Exams Question on my mail. It is so useful use to me.
DIFFRENCE BETWEEN ISO AND TS
