Interested to Buy Any Domain ? << Click Here >> for more details...
suppose we using 3 phase motor of 440 v means what range
of C.T. is require for measuring current ?
- 9 Answers
- 11547 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish khamparia
for C.T. rating we should have motor rating in kw. so that
we calculate the load.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
how we can explain arc heatng?
What is the automatic voltage regulator with servomotor?
If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
What is the dependency of stiffness on load angle??
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
State the points to be considered for selecting a particular type wiring.
If we want to change a contactor of faulty one what are the conditions want to fullfil
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
how will we calculate the copper wire load..
what percent do you derate your copper wire when you change from copper buss to copper wire
Define damping ratio.
