Interested to Buy Any Domain ? << Click Here >> for more details...
Pls say , how we calculate lux / sq.ft, which formula used
for calculation
- 5 Answers
- 18722 Views
- I also Faced
- E-Mail Answers
Answer Posted / aarya
To Calculate the no. of fittings in a room,
the formula is
N=No. of Light fittings required= A x E/(Lxuxd.f)
.'. E= N x (Lxuxd.f)/A
where L=> Lumen o/p
A=> Area (m^2)
E=> Illumination or Lux levels (in lux)
u=> coefficient of utilization
d.f=> Depreciation Factor
For Detail study refer Philips,G.E(lighting)& Artlite
Catalogues.
| Is This Answer Correct ? | 18 Yes | 5 No |
Post New Answer View All Answers
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is the source of dependent source ?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
How to connect the chemical earthing and complete process tell me plz
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
working principle of oil startar
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
what is the usage of microcontroller in the panel board?
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
