Answer Posted / mail2noor.hyd
Transmitter is electronic device, when excited with 24V dc
supply to the transmitter it sense and measure the physical
varible like pressure and send the signal (4-20mA)to controller.
Transmitters are Pr.transmitters,
DP " " " (LEVEL AND FLOW)
Temp " " "
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
How digital input and digital output 's are working in dcs
How the warning lamp of a charging-system is activated ?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
Differentiate between ultrasonic flowmeter and radar type flow meter
what is the criteria to decide conductor size of a cable ?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
What is the reason PT speed not incresed in gas turbine?
what is the procedure of O2 sensor(ABB) calibration?
ORP sensor working principle?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)