Answer Posted / ravi
where orifice plate is used to measure flow alone, the
signal is square rooted. it is by the formula Q=K square
root of Differential pressure. If other types of FT are
used then the signal from that FT need not to be square
rooted.
| Is This Answer Correct ? | 37 Yes | 23 No |
Post New Answer View All Answers
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
Explain about safety integrated level protection? . How it was differ from other protections ?
why would you like to join our company
What is the difference between PLC and DDC?
What is difference between radial vibration and axial vibration explain in detail .
Draw block digram for well head from well to shipping pump?
explain key exchanges in all security modes WPA,WPA2,TLS?
Questions on flow meters,few questions on HART protocol,
Give Detail information about plc,dcs,and scada system?
How to convert milliampares into flow??
Draw a great bridge circuit.
How will you calibrate PID controller? explain with example.
How to calibrate capillary type level transmitter
How to work temperature gauge?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
