Interested to Buy Any Domain ? << Click Here >> for more details...
how we are measuring the winding temperature of the
transformer?
- 11 Answers
- 36578 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishal shah
hello Mr. V Ram
Windin Temp. Can be measured with the help of Inbuilt-
Thermal Image type WTI (Winding Temp. Indicator)
The Winding is the component with highest temperature
within the transformer and, above all, the one subject to
the fastest temperature increase as the load increases.
Thus to have total control of the temperature parameter
within transformer, the temperature of the winding as well
as top oil, must be measured. An indirect system is used to
measure winding temperature, since it is dangerous to place
a sensor close to winding due to the high voltage. The
indirect measurement is done by means of a Built-in Thermal
Image.
Winding Temperature Indicator is equipped with a specially
designed Heater which is placed around the operating
bellows through which passes a current proportional to the
current passing through the transformer winding subject to
a given load. Winding Temperature is measured by connecting
the CT Secondary of the Transformer through a shunt
resistor inside the Winding Temperature Indicator to the
Heater Coil around the operating Bellows. It is possible to
adjust gradient by means of Shunt Resistor
In this way the value of the winding temperature indicated
by the instrument will be equal to the one planned by the
transformer manufacturer for a given transformer load.
logon to www.scientificcontrols.com for further details
regarding OTI & WTI
| Is This Answer Correct ? | 33 Yes | 1 No |
Post New Answer View All Answers
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
What is the formula to find out two phase active & reactive power
why the projects getting loss?
what is plunger and what's the use of it in motor alignment?
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
why genarator genarating voltage 11 KV?
what is the voltage between earth & neutral in 3 phase electrical connection.
What is difference between YNyn0 and YNyn ??
What are the classifications of oscillators?
how diside ct mf exmp.200/5 ct
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
List of equipments required foe industrial repair lab.
