sir, plz tell me how much kvar capacitor required for 1000
amp or 500 Kw load ? what is the formula ?
Answer Posted / shovan
Madhu pls explain what is tanphi1 and tanphi2????
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what is ramping rate of generator
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
In CTs tan delta point should be earthed , what is the reason behind it?
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
How energy is generated in hydroelectric power plant?
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
what is different between phase and netural
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
What is the basic rule for block diagram reduction technique?
how to calculate the lightning arrester conductor @ no of earth pits required
any one can explain the stages of a knee point which is taken during ct magnetising curve.
Is there any type of starter for DC motor other than two point,Three point and Four point starters?