Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chandrasen mourya
Its Basically the requirement of the client.
ie. The client operationg load along with consideration for
future loads. This gives you the power, now for the Volatge
& current we have to do a bit survey regarding which
voltage level is available in the vicinity & the availibity
of the same from the electricity board. This gives us the
Volatge rating & current is now calculated.
Now we have to see what protection are required & depending
on that we select the no of cores in both The CTS & PTS.
| Is This Answer Correct ? | 5 Yes | 11 No |
Post New Answer View All Answers
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
What is corkscrew rule?
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
Whether the vacuum contactor requires Short circuit protection?If No,why?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
what is the responsibility of C license holder in industry?
Why CBCT rating is 50/1A
Why do not we prefer non conventional sources of energy to conventional sources?
