How do you protect your appliances from harm in case of
neutral failure in a three phase power supply set up.
Answer Posted / lokesh ranjith
If nuetral fails in three phase system nuetral floats then
230 volts in will become 420V caused damage to the
equipment
Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
what is the difference b/w ATS and HTS?
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
difference between high and low impedance BUS BAR relay??
How CFL &T5 tube light glows?
what is the Transformer Impedence?How can calculate?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
Write down the name of 2 lady Bir Pratin of Bangladesh
what happens if dc supply is given and the remedies for it.
How to work E.L.C.B and how to connect in circuit.
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
what is your aim
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
can anybody sent me power grid questions. what subject should i prefer for preparation?