Will u plz give me simple diagram for tube light connection
& also function of chock?
- 8 Answers
- 25479 Views
- Bhushan Power Steel, Dalmia Group, Jindal, Practical Viva Questions, TCS, Windmoller, I also Faced
- E-Mail Answers
Answer Posted / engr. arbab waheed ahmad
there are two types of tube lights
1) with starter
2) without starter
1)for "with starter" the connection diagram is connect the
upper two pins of tube with two pins of starter and the
from lower two pins one is connected to the neutral wire
and the other is connected to the phase wire through choke.
function of choke is that when current changes due to
starter it produces a high voltage in 1000v range to ionize
the gas inside the tube according to the eq.
V=Ldi/dt
| Is This Answer Correct ? | 42 Yes | 10 No |
Post New Answer View All Answers
what about the power of wattmeter at starting and loding?
How to calculate cable size by using load.?? Any formula...
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
what is positive , negative & zero equivalent system resistance
can we do the star delta connection of capacitor for 3- phase motor starter.
what is the difference between capacitive and resistive voltage divider?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
What is marx circuit?
what is transient voltage?
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is gridrotor resistance starter
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
How to size fuse? How to size MCB?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
