Answer Posted / jagjeet

Dear Satish
The power factor dependent on the loading factor of the
induction motor , You can measure the Line current and apply
the formula suggested by Zakir or you can refer the
characteristics charts of Motor to find out the Power Factor.

what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?

5125

---

How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???

2052

---

what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.

2075

---

In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?

1707

---

The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input

2256

---

Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?

2126

---

pls tell us AC plant are how do work and parts name with picture

1956

---

What is the Minimum winding resistance of motors ( small & big)? referance range

2295

---

explain comutator action in detail.thanks

2249

---

my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.

2045

---

What is sink and source?

1177

---

how to calculate current and voltage in a same circuit?

2207

---

I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?

1662

---

plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?

2297

---

how to carried out DAR test in 11 KV Alternator ?

2288

---