Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raj
Just add one resistor of 250ohm
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
work of choke in florocent tube circuit ?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
What is the formula to calculate a three phase alternator
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
specify the inbuilt protections in DG
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
State thevenin’s theorem?
What are the advantages of hydropower?
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
how to estimate wiring ins roughing ins. and boxes
