Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when power factor is leading in
distribution of power?
- 10 Answers
- 23599 Views
- AMET, JTO, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / salahudeen
dear frnds,
if pf leads then amount of power form sorce to
compensate reavtive power is very less & current value
reduced hence conductor size & swich gear size also reduced
for any clari
contact
| Is This Answer Correct ? | 16 Yes | 12 No |
Post New Answer View All Answers
sir pls send the je exam - 2008 and other model question papers..
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
is oil viscosity affect on motor current?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
What is electrical diversity factor in electrical installations?
How do apply electrical 'c'license......pls advice
thyristor controlled APFC panel design parameter?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is effect of leading power facter on the system and billing
How to calulate Locked rotor amper(LRA) for compressor type motors?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
