Answer Posted / jignesh parekh
Wrms that means Watt root mean square.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Identification of ss fittings, pilot valves, relief valve.
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
How servomotor controls throttle valve of TURBINE?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
Make Heater Process Logic.
What is the use of control cable?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
Explain types of valves?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
How d.p. Transmitter can be applied to open tank?
How d.p. Transmitter can be applied to close tank?