Interested to Buy Any Domain ? << Click Here >> for more details...
why we are not earthing ht cable at both the ends(sending &
receiving end)?
- 5 Answers
- 14115 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / felixraj
only signal cables should earthed at one end. HT cables can.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is the difference between surge protection capacitor and surge arrestor
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
What is gain margin?
neutral earth resistance testing is it possible for transformer while in load condition
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is pi controller?
What are stable systems?
What's the difference between non break power supply and non break non short break power supply
What is the approximate value of stacking factor?
Why efficiency of generator is higher than motor at a particular load?
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
how external lighting design? please give examples?
What is signal flow graph?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
