What is the min and max ohmic value for earthing?
- 15 Answers
- 36046 Views
- NewTek, Wipro, I also Faced
- E-Mail Answers
Answer Posted / ahmed
It depends on the system and the resistivity of the
soil .Minimum is less than 1 ,Maximum is 10 ohms .
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
What is process of anneling transformer core
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
can i use 2000/5A Clamp meter to measure HT cable
what is RNG in the DG synchronizing by PLC?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
Why front mounted CT polarities are always towards breaker?
