Interested to Buy Any Domain ? << Click Here >> for more details...
i heard that power factor(PF) is the main concern for
industries, if they are maintaining PF around 0.6 they will
be fined for that. now the question is, how can they improve
the PF ranging between 0.9 to 0.95 which is safe for them
i,e escaping from the fine?
- 5 Answers
- 7670 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit biswas
inddustries mostly use static variable compensation (SVC)
technique for pf improvment.
Nowwhy dose pf drops? Due to inductive loads(eg.due to
arcing furnaces)
what SVC scheme dose is it proptionatly increases
captcitacne with inc. inductance or vice versa.
also using syc. motors can improve pf
(remember sync. motor is also called sync. condensor)
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
which types of relay used in acb and vcb?
How to reduce -234126219.6403 MVAr generation and by what?
Grid fault level [KA]?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
Why power genaration in India is at 50HZ while America its 60HZ
what should be the acceptrd value of winding resistance for 2.5MVA transformer
what is the solution for meger test failed the MV cable?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
What is the numerical quantity of sqcm?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
How one can check the MAIN of a house wiring ?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
