Interested to Buy Any Domain ? << Click Here >> for more details...
how manys ways dp transmitter can be calibrated having
range of -150 to 400mmwc,what side pressure u will apply?
- 3 Answers
- 8157 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh makhwani
We always have to apply pressure on the high side of the
transmitter. You cannot apply pressure on the lower side,
though if you will apply it gives you the negative reading.
| Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
What is Positive Calibration and Negative Calibration?
How is work 5/2 sov?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
What is standard procedure of manual mapping in Radar type level transmitter?
What is voltage regulator?
defination of radial vibration?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
if my flow is 20000 m3/h than which range of DPT i have to use????
the output of the common trasmitter protocol in qatar gas are the following
what is the input of digital counter during the the calibration time?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
which type of signal used in instrument?
Calibration procedure for Electro magnetic Flow meter
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how to work MIL contol valve posistioner ?
