Getting nusense tripping in a 11KV soft starter, have
checked all it control supply & contactors but did not get
any fault please help.
Answer Posted / arun
Check your load.Check the relay settings and current
measured during starting.
Check winding resistances in each phase,earthings,IR values
of the motor.
Run the motor without load for sometime if possible monitor
the current in each phase.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Why is better to have a minimum ceiling voltage of 250% than 160%?
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
what is the id1 & id2 setting in differential protection relay of CSPC?
Percentage losses in power generation?
What is non-minimum phase transfer function?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
how 650 volts creates? where is use?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
Q: How to calculate Transformer losses , tell us by Formula.
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What are the significant parts of dc generator?