If the supply voltage is same (say 440V) whether a system
designed for 60 Hz frequency will work with 50 Hz frequency
or not , if so pl. give clarification.
- 11 Answers
- 13277 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rameshpaulaian
Its work both 50Hz and 60Hz , but the output is diff from
each.
Ex: Fan, Speed of fan at 60Hz< Speed of Fan at 50Hz.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
3phase cable calculation formula by motor load
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
What are the operation carried out in thermal power station?
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
Is RTCC panel needs any control supply.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
Define active filter?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
Define damping ratio.
What is mean by Sensitive Earth fault & what are the effects
