Interested to Buy Any Domain ? << Click Here >> for more details...
1.Can anybody explain Why starters are not used for motor
starting in industries?
2.
- 7 Answers
- 8801 Views
- I also Faced
- E-Mail Answers
Answer Posted / arun_sekar_1986
No for low rating of motors starters may not required.But
for higher rating starter is Mandatory. To reduce high
starting current starter are used while starting in step by
step it is used.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what the principle of sincroscope?how it works?when it needed?
What happens if we connect a single phase energy meter in reverse polarity.
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
what is transistors comprised of?
what is the difference between earth leakage and earth fault?
How can we calculate ac current from the given DC current when AC voltage is given?
Difference between megger test equipment and contact resistance meter test instruments?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
Briefly describe your ideal job?
why the projects getting loss?
what is the voltage rating of chiller unit sensors
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
