what is different the DOL Starter and Star Delta STARTER
Answer Posted / natarajanramkumar
D.O.L Starter=Direct On Line Starter
1.It does not decrease the starting current.
2.It is cheap.
3.It connects directly the motor with supply for starting
as well as for running.
Star-Delta Starter
1.It decrease the starting current to 1/3 times.
2.It is costly.
3.It connects motor first in star at the time of starting
then in delta for running.
| Is This Answer Correct ? | 257 Yes | 16 No |
Post New Answer View All Answers
What is the unit of attenuation?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
what is the control circuit for operating the clean room air shower
What is the difference between Droop vs Isoch Control?
How cable from Kit-Kat to main switch, from starter to motor are designed?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
can someone explain that how the speed of the protection system affects the fault level calculation?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
how can calculate 1kva generator running time in 1 liter keroscene
Why do we use copper cable for HT Supply and why not Aluminium?
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????