how do you calculate IKW(consumption per TR) in HVAC?
- 27 Answers
- 139491 Views
- Aircon, CBRE, Cipla, Clivet, Cushman Wakefield, JLL, Sodexo, Voltas, Wipro, I also Faced
- E-Mail Answers
Answer Posted / giri
1 TR(ton refrigeration)= 3.5KW.........
| Is This Answer Correct ? | 325 Yes | 49 No |
Post New Answer View All Answers
which capacity of RCCB used for five thousand watt electricity load?
impliment (AB)`+C to transistor representation
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
why swityard is necessrry requirement in any bis power distributin systems?
what is draiv work
How to resolve if Diesel generator stop while running ?
what is the difference between oil surge relay and buchholz relay.
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
