what is the type of winding connection( star or delta) in
1HP to 5HP motors. How to check the motor winding
connections( star or delta) if not provided in the
nameplate?
- 5 Answers
- 18942 Views
- I also Faced
- E-Mail Answers
Answer Posted / shri..
As per my knowledge in star connections only three leads
are coming at terminal box.
And in star delta winding six leads are coming in terminal
box.
In star connection DOL starter are using.
In star delta starters
When pressing on button of starter the starter make star
connection after releasing the button starter makes delta
connection.
| Is This Answer Correct ? | 21 Yes | 25 No |
Post New Answer View All Answers
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
what is the purpose of bypass mode in energy lighting transformer?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
Why ground terminal is used in pot meter 10k ohms
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
In parallel operation time both NGR’s close or not close if both close what will happen
draw singleline diagram of star to delta and dol starters
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
how to failure indution motor insulation & how to improve heat in motor insulation
What happen in ups if phase reverse?
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
