Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / md. zakir hosen
We know that,The air gap controls the amount of magnetic
field produced for a given current. In the equation
∫H·dL = n i , H is quite small in the iron because of its
high permeability. Nearly all of the integral accumulates in
the air gap even though the gap is very small compared to
the part of the closed path length in the iron. It reduces
the tendency of the iron to saturate to avoid harmonics in
the current.
thanking u
http://a2zengineering.blogspot.com/
z_hosen@yahoo.com
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
what is feed back and what are feed back amplifiers?
What cmos is and its benefits?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
On what principle electric motor works?
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
How much of the total hydro power potential has been exploited so far in india?
can i able to get bhel previous exam question paper?
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
what is a vector protection in transformer
What is the difference between the impedance percent and impedance voltage ?
Define cut-off rate?
what kinds of Transformer oil grade is better for power transformer ?
What are the basic elements used for modeling mechanical rotational system?
