Interested to Buy Any Domain ? << Click Here >> for more details...
Can anyone tell me what will happen if AC & DC supply get
mixed???
- 9 Answers
- 17319 Views
- I also Faced
- E-Mail Answers
Answer Posted / md. zakir hosen
We know that ac current also contain dc part or parameter.
but in practical case when any dc supply mixed with an ac
supply then a abnormal situation will occur and system will
be unstable.but small quantity of dc may carry or used with
ac system.
thanking u
z_hosen@yahoo.com
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What’s electric traction?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
What test must you do before powering up a circuit that you have been working on?
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
working principle of AC Servo Motor with its construction
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
what is spadar bar .why I use in DC generator.
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
how can we calculate the ratio of caustic soda and water in lrs.
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
what is the main difference between power devices and signal devices
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
