Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prakash suhane
Control ckts are design on DC because
1) unlike to AC, DC is constant wrt time hence no
fluctuation provide better stability in control ckt device.
2) As there is no frequency hence no leagkage current again
safety of control device.
3) DC as compare to AC is quickest means of isolation.
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
model question paper for supervisor trainee
what is LSR?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
What is transformation ratio what it describes?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
two way ckt diagram can be drawn by how many ways? give diagram
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
In Power cable specification what is U0/U and Um.
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
exolain the star delta connection
What do you mean by passive circuit elements and why these are called passive?
substation+ plc system
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
