Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gopal
when ever current caqrring conductor is placed in a
magnetic field a force is experienced in that conductor.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Difference of induction motor & servo motor ??
how to calculate the conductor size for certain KV transmission line and distribution line?
what is circuit breaker in transfomer and where it used
briefly explain the main blocks found in a microprocessor based system
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
How to calculate VCB rating for 33KV ,25 MW Power line?
How to calculate Voltage regulation of 22 KV Over head Line.
