what is the function of a commutator in a dc generator?
- 14 Answers
- 72008 Views
- College School Exams Tests, NTPC, TCS, I also Faced
- E-Mail Answers
Answer Posted / gururaj
COMMUTATOR IS WORKING AS A RECTIFIER.IN DC MOTOR IT'S USED
TO CONVERT THE AC TO DC.
| Is This Answer Correct ? | 37 Yes | 9 No |
Post New Answer View All Answers
which type of cabel
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How many types of circuit loads are there in a common electrical circuit?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What safety precaution are to be taken for avoiding electric hazards ?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
Whether the vacuum contactor requires Short circuit protection?If No,why?
how rectifier transformer work in electroststic precipetatore(esp?
What is nichols chart?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
How shall i select the value of capacitor or inductor in a system?
