What is difference between miniture circuit breaker and
module case circuit breaker up to 63Amp.
- 7 Answers
- 12516 Views
- MSPL, I also Faced
- E-Mail Answers
Answer Posted / sennapparajan
MCB can be used for only over current triping.
MCCB can be used for over current and earth fault(in built)
triping.
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
Explain cmrr?
Star Delta Diagram with full description
how to calculate magnetic force genrated by a coil ?
how we calculate the short circuit capacity of the busbar in LV & HT?
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
Why we use mho Relay in long transmission line?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Details about Flux Compensated magnetic Amplifer starter for motors
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
during installation time of transformer and alternator which points we have to observed?
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
state the working of discharge lamp?
lorteny method
why induction motors are rated at 0.8 power factor.
