Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between MCCB & ACB & VCB
Answer Posted / rabindra dhungana
MCBs are miniature circuit breakers with optimum protection
facilities of overcurrent only.These are manufactured for
fault level of up to 10KA only with operating current range
of 0.5 to 63 Amps (the ranges are fixed), single,double and
three pole verson.These are used for smaller loads
-electronic circuits,house wiring etc.
MCCBs are Moulded case Circuit breakers,with protection
facilities of overcurrent, earth fault.it has a variable
range of 50% to 100% operating current.They can be wired for
remote as well as local operation both.They are manufactured
for fault levels of 16KA to 50KA and operating current range
of 25A to 630Amps.They are used for aplication related with
larger power flow requirement.
| Is This Answer Correct ? | 25 Yes | 13 No |
Post New Answer View All Answers
how to calculate the distance relay faulty zone?pls explain?
What is mean by Sensitive Earth fault & what are the effects
State and define ohm’s law?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
what is the principle of operation of CFL ??
what is zinc diffusion?
Why we find the sensitivity for the CT's to check?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
How to Make relay co ordination chart for a Electrical power distribution of a plant
what is the safety points of vaccum circuit breaker.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
Difference between rating factor of cable and derating factor of cable?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
what are the application of over current relay?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
