Generally in AC we consider voltage, frequency and phase
sequence for parallel operation ... Can we parallel two DC
battery chargers? If yes, then what precaution to be taken
when we parallel two DC power?
- 5 Answers
- 6538 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / vijaykumar shetye
1) Yes, theoretically, we can parallel two DC battery
chargers, but generally they are not designed for parallel
operation.
2) Following factors are to be considered.
1) The voltage of both the chargers should be the same.
2) Both chargers should be connected in the same
polarity.
3) The output impedance of both the chargers should be
the same, so that both deliver equal current. (It is not
necessary that both the chargers should be of the same
make. It would rather prefer same model than same make.)
4) The characteristics of both the chargers should be the
same. Both should be set at the same current setting for
changeover from boost to float.
5) The current capacity of both the chargers should be
the same.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
Draw a block diagramof Three UPS systems connected in Parallel mode?
66kv under ground cable how to layaing in ground any special case two ckt r runing
Is any generator is developed which is operated with out diesal or other expensive source?
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
Explain marx circuit.
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
State and define ohm’s law?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
How the annunciator works ? How to do its wiring
how brushed dc motor operating ?
errection check list for transformer maintenance
What is meant by celling voltage & current in excitor ?
State The Difference Between Generator And Alternator?
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
