Interested to Buy Any Domain ? << Click Here >> for more details...
when a three phase motor in running condition consumes 2A
in each phase,and if one of the phase gets fails what will
be the consumption in other two phases
- 4 Answers
- 6820 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant
for a three phase motor do work properly all the 3 phases
must be active. In case if one of the phases fails then the
motor will not work properly ( SHOULD ACTUALLY STOP
ABRUPTLY )and may probably give a loud whining noice.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
what is a bus riser in power system and why it is used
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
what is the effect of un-synchronized power.
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
WHAT IS THE PARTIAL DISCHARGE TEST?
what is the reqirred voltage in HT motor to get full RPM on no load test?
hello if any one have papers vof hpcl or sail, plz send me
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
i've iocl interview.. if you know the interview process please give me information..
Motor,transformers,capacitor tubelight etc....
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
