Interested to Buy Any Domain ? << Click Here >> for more details...
How much voltage we get between two wire of 4 to 20 ma
output? Is this voltage up or down respectvice to 4 - 20
ma ?
- 9 Answers
- 14511 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiran
normally you gets 24-30VDC diretly connecting the volt
multimeter acroos it.
Also depends on the connecting the load resistance across
it.
E,g. When you are connected the 250 ohm load across it then
you get 1-5 volt or for 500 ohm 1-10 volt up & dowm
respective 4-20mA.
| Is This Answer Correct ? | 23 Yes | 4 No |
Post New Answer View All Answers
How to Calibrate Temperature Switch in field
Explain an adaptive / self-tuning controller’s major draw card.
Question on maha cement
what would be the minimum flow rate that we can measure on rotameter..?
what is piezoelectric transducer?give an example in power plant n state its principle?
How the sizing of the analog signal cable is calculate?
Explain plc level and its type?
how to relay switch sense the fault?
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
What is intrinsically safe system?
How will you calibrate PID controller? explain with example.
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
What is the difference between mmwc and mmwg?
