WHAT IS THE THUMB RULE FOR DECIDING THE CURRENT RATING OF
COPPER WIRES SAY 2.5/4/6/10 MM SQUARE SIZES??
Answer Posted / prashant
IBELIEVE
1.5 SQ MM - 5A
2.5 SQ MM - 10A
4 SQ MM - 15A
6 SQ MM - 20 A AND SO ON
Is This Answer Correct ? | 66 Yes | 142 No |
Post New Answer View All Answers
in india per day how much power is generated including all power station
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
Give atleast 20 alternating current apparatus and devices.
difference between high and low impedance BUS BAR relay??
how can we make cable shedule for controll wiring ? which details must be required for it.?
what is the cause of voltage dipp or swell in the transmission lines?
What is the main use of rotary phase converter ?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
what is the meaning of WYE and DELTA in Electric meter?
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
what is the use of piston rings in the engine used for a generator...........
What is difference between slip rings and carbon burushes?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor