Interested to Buy Any Domain ? << Click Here >> for more details...
Why size of HT cable is less then LT cable inspite of the
fact that voltage is higher in HT cable?
- 2 Answers
- 8425 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / rainy
Hirer the voltage the lower the current. And the lower the
voltage the lower the current. Say for instance if you were
feeding the high side of a transformer with 230kv and the
sec. side was 100kv usually the size of conductors would be
(high side 1 mill. and on the low side would be 2 mill.
wire size usually dual conductors to carry the load on the
low side.
| Is This Answer Correct ? | 6 Yes | 14 No |
Post New Answer View All Answers
how to modify DOL control panel into Delta Y connection?
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
Why have to use copper cable for local isolator to motor ?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
What is mason's gain formula?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What are electric motors?
What is super thermal power plant? and how it will differ from normal thermal power plant
How to calculate the fuel consumption for 600kva DG genset which connecting with 25%load?
How to know the Max. current caring capacity of the cable by its size ?
why the India electrical supply transmission loss is high when compare to us
Why neutral cable carry current.
why co incidence factor considered in transformer sizing?
