Interested to Buy Any Domain ? << Click Here >> for more details...
Why size of HT cable is less then LT cable inspite of the
fact that voltage is higher in HT cable?
- 2 Answers
- 8184 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / mohit kochhar
size that is the cross sectional area of cable that is in
Sq mm. mainly depends on current carrying capacity of cable
and second on voltage if voltage increases than the
current decreases. so in HT that high tension above 1.1 Kv
current carring capacity decrease for transferring the same
amont of power. so is the size reduced . yes it has extra
insulation for this high voltage.
| Is This Answer Correct ? | 37 Yes | 2 No |
Post New Answer View All Answers
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
how does a submersible pump work..?
What is meant by reset level of the relay?
How earthing of switchgear system to be done.
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
Name a govt approved university which have 100% online engineering course.
Pls mail me utility & Dg related question with answer
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
What is capacitance?
how to calculate power consumption in slip ring motor at different step
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
how can i change the rotation of the AC single phase induction motor and show me by diagram
What is a copper loss or i2r loss pc?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
how to calculate the conductor size for certain KV transmission line and distribution line?
